RETAINING PIN OPTION

Rakks brackets with retaining pins provide an extra measure of security, keeping shelves from shifting on the brackets. Wood shelves with 1/4″ holes or slots fit over the pins. When supporting long shelves across several brackets only the outside brackets need retaining pins. Double-sided foam tape is also effective in securing shelves to the brackets.

retaining pin option

SHELF COUPLER

Used with Rakks Style brackets to allow two shelves to join at a bracket. Couplers (2 per bracket) are only required on the bracket where the two shelves join. Pre-drilled holes in the couplers allow the shelves to be screwed into place. Available in white, black and translucent.

shelf coupler

STICK-ON SHELF RESTS

These transparent polyurethane pads cushion glass or wood shelves and keep them from sliding on the brackets.

stick-on shelf rests

NOTCHED BRACKET

Used to hold 1/4″ x 1-1/4″ hangbar for merchandising clothing or for use in closet applications. Hangbar can also be used as a stiffener for glass or wood shelves to reduce deflection over long spans. Notched brackets can be made to any specified length and notch location.

notched bracket

HANGBAR STIFFENER

Sold in cut-to-length sizes up to 12′- this 1/4″ x 1-1/4″ anodized bar fits into notched brackets.

hangbar stiffiner

J-HANGBAR

This attractive profile provides extra stiffness for wide spans or heavy clothing. Can be mounted at the end of notched BR2 bracket (shown) or supported on J-Bar Brackets described below.

j-hangbar

SLANTED BRACKET

Rakks Style bracket can be manufactured to lock in at any angle. This configuration is ideal for literature and magazine display. Retaining pins at end of the bracket fit into the bottom of the shelf to keep it in place.

slanted bracket

WATERFALL BRACKET

Used for merchandising and display, brackets can be made to any specified length, angle and pin configuration.

waterfall bracket

WIRE FACE OUT BRACKET

Wire Face Out Bracket fits over BR-Hangbar and can be used for the merchandising and point display of card mounted product. Available in 4″, 8″, and 12″, silver powder coat only.

wire face out bracket

BR BOOKEND

Rakks Style brackets make excellent bookends. Specify bookends one size smaller than the shelf depth. Note: bookends must be installed in sequence with (and at the same time as) the shelf brackets.

br bookend

UNIVERSAL BOOKEND

A wire formed bookend that can be installed into the front of standards or poles at any point. Powder coated silver, black, and white to match other components. Available in 8″ depth only.

universal bookend

DESK BRACKET

Used to support work-surfaces from 20″ – 24″ deep – these T-style brackets are reinforced for added strength. Rated at 120 lbs per bracket.

desk bracket

Site Design by Laidlaw Group